Launch Accessories

Designed to support multiple common launch rod sizes in Rocketry Works' Wallops Island 1010 rail launch pad, this 3D printed adapter supports 1/8 inch, 3/16 inch, and 1/4 inch launch rods so you can launch rockets that lack rail guides from your Wallops...

Rocketry Works designed our 3D printed launch rod safety caps to be durable and they're made of easy to see colors that are easy to spot when dropped on the ground. Use them to cover the top of your launch rods when you are not launching to protect...

These replacement igniter leads for the Houston launch controller connect to the Houston launch controller's distribution box using RCA connectors and feature stainless steel igniter clips are easy to clean and are marked with red strain relief. They are...

This extended length igniter lead allows you to place an away pad 15, 25, or 35 ft away from the main pad. Designed to work with the Houston launch controller's RCA port igniter connectors, the lead is made of sturdy 18 gauge lamp wire, with hand...

Rocketry Works Clip Whips are built sturdy for many years of success launching clusters or conducting multiple simultaneous launches.  Ranging in number from 2 to 6 igniter leads, they are made of durable 18 gauge lamp cord, and range in length,...

Rocketry Works launch pads are all compatible with this launch rod mount. While the PLA material used in its construction resists the heat of many low power rocket launches, these do wear out over time. All launch rod mounts used in Rocketry Works...

Rocketry Works launch pads are all compatible with this launch rod mount. While the PLA material used in its construction resists the heat of many low power rocket launches, these do wear out over time. All launch rod mounts used in Rocketry Works...

Rocketry Works launch pads are all compatible with this launch rod mount. While the PLA material used in its construction resists the heat of many low power rocket launches, these do wear out over time. All launch rod mounts used in Rocketry Works...