Nose Cones

Number 9 lead shot helps maintain stability when upgrading motor size on short, stubby rockets. Use simulation software to calculate the amount of nose weight you'll need for your particular rocket, and choose the amount of shot you need, in grams from...

This nose cone is an 4.15 inch (10.5 cm) long 3D printed ABS plastic ogive nose cone for BT-60 body tubes. It's a 2 piece nose cone with vents for accurate barometric altimeter measurements--the shoulder and nose cone separate with quick release plastic...

This nose cone is a 6.5 inch (16.1 cm) long 3D printed ABS plastic ogive nose cone for 2 inch body tubes.  The shoulder includes a shock cord attachment strut. The 3D printed texture can be smoothed out with some wood filler and sanding. This nose...

Type a description for this product here...

This nose cone is an 5.5 inch (14 cm) long 3D printed ABS plastic ogive nose cone for BT-70 body tubes. It can be used for TARC teams, or for general hobby rocket construction. The shoulder includes a shock cord attachment strut. The 3D printed...

This custom 3D printed ABS plastic ogive nose cone is up to 8 inches (20.3 cm) long for 3 inch body tubes. Note that there are a variety of "3 inch" body tubes available, each with slightly different outside and inside diameters. To better fit your...

This nose cone is an 5.25 inch (13.3 cm) long 3D printed ABS plastic ogive nose cone for BT-60 body tubes. It's a 2 piece nose cone--shoulder and nose cone that glues together with epoxy. at 1.6mm thick walls, it's a sturdy nose cone. Typically, fliers...

This nose cone is an 8.25 inch (21.2 cm) long 3D printed ABS plastic ogive nose cone for BT-80 body tubes. It can be used for TARC teams, or for general hobby rocket construction. The nose cone is sturdy at 1.6mm thick, and comes in 2 parts--the...

Custom 3D printed nose cone, subject to quote from Rocketry Works. Typically, these nose cones are smaller than 3 inches in diameter. Contact us to discuss details. 520 405 3009

Designed to allow flights of Jolly Logic altimeters in 24mm diameter airframes like the Rocketry Works Socrates or Toobish kits, this 3D printed ABS nose cone fits in an 24mm (BT-50) body tube and attaches to the shock cord just like a typical nose cone...

Designed to allow flights of Jolly Logic altimeters in 18mm diameter airframes like the Viking, this 3D printed ABS nose cone fits in an 18mm body tube and attaches to the shock cord just like a typical nose cone.  But this nose cone flares out to...

Ideal for egg lofting and TARC models, this flexible foam BT-70 nose cone features a smooth finish, and it helps absorb the impact of landing a fragile payload. The foam material in this nose cone is is highly compressible, providing superior cushioning...