Motor Hardware and Accessories

Motor Hardware and Accessories

  • 18-38mm Delay Drilling Tool

    Aerotech

    18-38mm Delay Drilling Tool

    MSRP: $19.99
    $16.99
    Adjust the delay on Aerotech RMS 18, 29, or 38mm motors with the 18-38mm Delay Drilling Tool. This tool allows you to remove 2, 4, 6, or 8 seconds from the default motor delay by removing delay grain with the the built-in drill bit in specified...
    AT-T-082510-1
  • Aerotech

    1cc Super-Lube Grease Pack

    MSRP: $0.49
    $0.42
    This lubricant serves to lubricate RMS motor casings and protect o-ring seals in RMS motor casings.  Follow the directions for your RMS motors to help ensure safe operation of your reloadable motors. These packs are h andy 1cc single use packs that...
    AT-99207
  • Aerotech

    3 Ounce Super-Lube Grease Tube

    MSRP: $5.99
    $5.09
    This lubricant serves to lubricate RMS motor casings and protect o-ring seals in RMS motor casings.  Follow the directions for your RMS motors to help ensure safe operation of your reloadable motors. This tube is a palm-sized tube of lubricant that...
    AT-99217
  • Out of Stock
    54mm RMS Delay Drilling Tool

    Aerotech

    54mm RMS Delay Drilling Tool

    MSRP: $19.99
    $16.99
    Adjust the delay on Aerotech 54mm RMS motors with the 54mm Delay Drilling Tool. This tool allows you to remove 2, 4, 6, or 8 seconds from the default motor delay by removing delay grain with the the built-in drill bit in specified measurements...
    AT-T-082510-2
  • Aerotech 29/60 motor casing

    Aerotech

    RMS-29/60 Motor Casing with Closures

    MSRP: $85.00
    $72.25
    Aerotech's 29/60 motor casing comes with forward and aft closures, ready to install your F37W or F62T RMS reloads.  Note that you must be an adult (18 years or older) to handle RMS reload kits.
    AT-2960M
  • Universal Delay Drilling Tool

    Aerotech

    Universal Delay Drilling Tool

    MSRP: $9.99
    $8.49
    Adjust the delay on Aerotech DMS single use motors with the Universal Delay Drilling Tool. This tool allows you to remove 2, 4, 6, or 8 seconds from the default motor delay by removing delay grain with the the built-in drill bit in specified measurements...
    AT-UDDT